I was able to get in touch with Provo Craft this morning. There was a little hold time, but all in all it was not too bad. (I have learned to call as soon as they open.) My customer service rep. was Jenny. She was very courteous, nice, & helpful. She listened to my entire problem & concerns, asked me a few questions. She put me on hold to check with a technical representative & came back to tell me that with what I am experiencing they will have to replace it. She did ensure me that it would be a brand new Imagine, not a refurbished one.
I had to return my original baby bug (at that time - they would send out a new one w/ a return label & you would return the broken one after you received the new one.) My experience then was very good. Now they are emailing me a label to send this one back first. She said turn around time is about 2 wks. Hopefully this goes smoothly & my next Imagine will not be sick.
Thank you Provo Craft & Jenny for very professional customer service.
Thanks for looking. Questions & comments are always welcomed. Lori
3 comments:
I hope everything goes very smoothly for you! Were you following my blog when I had my recent Cricut return saga? My advice call, call and call checking up on it all the time until you have that new baby in your hands!
Tara
Sorry to hear you had a problem with your Imagine. I got one for Christmas, but I'll be trying it out for the first time this evening -- thatis, if everything is okay with it!!!
Hope, however, you had a wonderful holiday!!!
i had a problem with my gypsy and had to send it back. it takes a while to get through to customer service, but that's my only complaint. they were fabulous! i was able to communicate with my cs rep through email after we got off the phone. there was a bit of confusion with my shipping label (i have a funky mailing situation), and my rep and someone else emailed me to apologize. it wasn't even their fault. i predict you will have no problems! also, the turn around time is pretty accurate. good luck, and congrats on the dt!
debbie
Post a Comment